Windows 7 Kernel Version 7600 MP (1 procs) Free x86 compatibleīuilt by: 7_rtm.090713-1255 All rights reserved.Ĭonnected to Windx86 compatible target at (Sat May 21 18:31:05.888 2011 (UTC 2:00)), ptr64 FALSE 633 X86Ĭopyright (c) Microsoft Corporation. Ok, copied kdpatch.sys and kdvm.dll to system32drivers and executed kdpatch.reg.Īfter reboot of the VM I get the following bugcheck: I will now look at the dynamic patching suggestions and come back with the results. Windbg -k com:pipe,port=\.pipecom_1,resets=0,reconnectĪfter WinDbg has loaded it should display: The suggested VirtualKD entry did not work for me, it just waits forewer. Now start the VM and select the new debug entry. – call “bcdedit /dbgsettings serial debugport:1” from a cmd with admin privileges – create a new boot entry, for example using EasyBCD or bcdedit, make a copy of your default boot entry and enable debugging for this new entry (bcdedit /debug on) – open VirtualBox manager, edit the VM and go to serial ports, activate port 1, port number = 1, port mode =Host pipe, check “create pipe”, pipe name: \.pipecom_1 We may install WinDBG Preview from the Windows Store (As of now there is no direct download).Ok, after some hours of struggling I got the COM debugging running.īecause some of the steps where unclear or wrong typed, here the correct steps, just in case someone else will find this posting: There is no working command line option as of now) WinDBG Preview has no command line option, but that’s the same for any WinDBG install on Windows 10. I’m not complaining, it turned out to be quite user friendly. This does not install correctly on Windows 10, however, so I was forced to use WinDBG Preview. (Author’s note: Originally, I wanted to do this with the regular version of WinDBG. Now, when we start our virtual machine, it will be kernel debuggable. This also gives me the ability to swap out, turn off, or modify the kernel debugger while the virtual machine is live) Every time I open my kernel debugging snapshot, it will automatically start the pipe. I find this option much better for convenient snapshotting, however. Normally the pipe is set up through the debugger instead of through the v irtual machine. (Author’s Note: This is the exact opposite of how it’s usually done. In the “Serial Ports” menu, we must check “Enable Serial Port”, select “Host Pipe”, uncheck “Connect to existing pipe/socket”, and enter our pipe’s name into the address.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |